In June PoliceMag.com reported on an officer with the Fort Worth (TX) Police Department who was very badly injured while attempting to end a vehicle pursuit by deploying a tire deflation device on a roadway
Officer Matt Brazeal reportedly suffered “catastrophic” injuries and will likely spend the next year—or more—in the hospital recovering.
Brazeal is not alone.
Earlier this year, we reported on the death of Bell County (TX) Deputy John Andrew Rhoden, who died while assisting the Williamson County Sheriff’s Office as a vehicle pursuit went from one county to another. Rhoden was attempting to deploy spike strips on an interstate to end the vehicle pursuit when he was struck and killed by a tractor-trailer truck.
Also this year, we reported on the death of a trooper with the Washington State Police who was attempting to deploy spike strips to bring a pursuit to a stop when the fleeing vehicle struck and killed him. Trooper Justin Schaffer was transported to a nearby hospital where he later died of injuries suffered while trying to end a vehicle pursuit with the use of spikes.
Every year it seems, officers are injured or killed while attempting to deploy tire deflation devices in an effort to end a high-speed pursuit.
The question becomes, “Is ending a vehicle pursuit worth risking the end of a law enforcement officer’s career or even their life?”
Altogether too many officers have been badly injured or killed deploying “spike strips.” Many of those injuries or deaths occurred while the officers were deploying tire deflation devices on an interstate freeway or rural roadway where speeds could reach more than 100 miles per hour.
It has been reported that as many as 30 people have been killed in the two decades since “spike strips” were introduced into police inventory, with some officers intentionally run over by drivers trying to evade the tire deflation devices by leaving the road and driving along the shoulder where the officers were trying to stay safe.
The deployment of tire deflation devices is not something an officer does with great frequency, and it is clear from some of the videos one can find online that officers doing this are simply improvising.
In a typical case, an officer attempts to manually apply the tire deflation device across the road in such a way that it impacts the suspect vehicle, and then quickly attempts to clear the roadway before the pursuing patrol cars cross the area.
The problem is—as is all too common in most skills of the law enforcement universe—there is not an abundance of training with these devices. Officers are issued “spike strips” with just the scantest guidance on how to safely use them.
And most of that training takes place in a department parking lot with skilled drivers who have no ill-will or violent intent—in fact, those trainers have the officer’s safety at the top of their mind.
This unnecessary danger of injury or worse can be avoided with just a few thoughts on how—and when—to use tire deflation devices.
The first rule of thumb on “how” to deploy tire deflation devices is to create a wide “buffer zone” between the roadway on which the strips are thrown and the officer deploying them.
Some agencies instruct officers to use a patrol vehicle as a shield, parking the squad car beside the road and deploying the spike strips from a distance ahead of the front bumper.
However, this can be counterproductive. The obvious presence of a squad car beside the road will alert the fleeing driver to the fact that there might be spike strips ahead. Further, the presence of the patrol car at roadside might make the subject leave the road and drive through the area in which the officer is taking shelter on the shoulder.
It may be best to deploy spike strips just beyond a freeway overpass, with a concrete abutment beside the road to protect the officer. Thick woods on rural roads also offer some level of protection.
Find Them Later
Then the question becomes is it necessary to even pull these devices from the trunk of the patrol car. In most cases, the answer to that is a resounding “no.”
In many police pursuits, the offender is the registered owner of the vehicle in flight. So finding that person at a later time would—in most cases—be reasonably effortless. Last known residence, employer, associates, places of preference, could easily be pulled from just the license plate.
Officers must assess the risk vs. the reward of putting holes in the tires of a fast-moving vehicle while standing dangerously close to the roadway on which that vehicle is moving.
Putting a cop in the path of a person who might commit an unimaginable act of violence with a two-ton projectile is not always worth it.
A vehicle pursuit is a dangerous business any way you cut it, but placing an officer beside the roadway with little protection and the unenviable task of tossing a tire deflation device out and then quickly clearing it from the road may not be the best strategy for bringing an end to the chase.
Are there instances in which the deployment of a tire deflation device is the correct tactical option? Absolutely. But other options should be explored before resorting to this low-frequency/high-risk maneuver, and every effort should be made to ensure that an officer engaged in this activity is protected to the best of the agency’s ability.
Doug Wyllie is contributing web editor for POLICE