All other controls function as usual and the LDA offers a firing pin safety like the Colt Series 80 pistols. Unless the trigger is depressed fully, the firing pin cannot go forward. This makes the gun safe against accidental discharge, even if dropped on the hammer spur.
Speaking of which, the rounded spur of the 7.45 LDA may interfere with some holster designs. Unlike a standard 1911 that allows cocked-and-locked carry, the Para runs with the hammer down and the safety on. This is an impossible proposition with a standard 1911 design, so holster makers were caught unprepared.
Most duty or concealment holsters for the 1911 design allow for cocked-and-locked (hammer back) carry, with the leather strap running between the hammer and the rear of the slide. These won't fit the LDA series. To complicate matters even more, some designs allow hammer-down, safety-off carry with standard 1911 pistols. Some of these holsters will push the safety down on the Para if the snap is engaged.
This can all be simplified two ways. You can buy the special law enforcement version of the LDA series, which has a spurless hammer. This allows carry in virtually any standard 1911 holster. Additionally, any open-topped holster without a thumbsnap works just fine.
Being a single stack, the Para holds seven rounds with one in the chamber. The magazine well is nicely beveled and aftermarket 1911 magazines should work fine. They should, however, be thoroughly tested before you rely on them for duty carry.
A Nice Package
All around, we'd rate the Para 7.45 LDA as being well made and nicely finished. The rosewood grip panels are checkered and of a rich color. While some parts are obvious castings, they seem uniformly finished with no obvious casting voids or pits.
The grip frame has what appears to be a soft, bead-blast finish while the slide flats are polished to about a 200 grit finish. An all-around handsome look, according to those who admired it at the range.
Ergonomics are first-rate and anyone familiar with a standard 1911 will feel right at home with the LDA. The safety being in the "on" position with the hammer down is disconcerting at first; but the natural, normal movement to engage or disengage the safety soon puts any butterflies to rest.
We unfortunately had to limit our range testing to 15 yards due to a match in-progress at the 25-yard facility. Still, this gave us a good idea of the performance possible with the 7.45 LDA.
We restricted our shooting to Federal Personal Defense ammo and Black Hills 230 gr. .45 ACP ball. Approximately 200 rounds of ball were put through the gun to break it in. There were two stoppages, both failure to chamber. This is not unusual for a new auto, particularly with a stainless gun that hasn't been broken in.
Groups with the ball hovered around the 1.2- to 2-inch size, depending upon who was shooting. It was very easy to stage the trigger and pull the last bit of engagement off like a single-action shot. The 7.45 LDA test gun would probably deliver 2-inch groups at 25 yards if the shooter was careful.
Federal PDA (the 185 gr. load) performed well and shot exceptionally tight groups, with some less than 1 inch. The fully ramped barrel of the LDA undoubtedly contributed to the reliability experienced during the test firing.
Performance from a variety of holsters (Uncle Mike's new Kydex design and some leather from various makers) was predictably uniform. Holster makers have managed the 1911 design for almost 100 years, so they pretty much have all the bugs worked out these days.
Some fast double-action work revealed a potential training issue. It was easy to "short-stroke" the trigger by not allowing it to fully return after firing. During the return, there are two distinct clicks a shooter can feel and hear. A shooter has to train to allow the trigger to return fully, a full stroke forward, before beginning the return stroke. Otherwise, the trigger locks up and will not pull to the rear.
Having said that, the same thing can be done with a double-action Smith & Wesson revolver. So it's not the end of the world, just something to be aware of.
This is a sound design idea and cleverly instituted. The trigger-bar that activates the hammer assembly seems lightweight, however, and we'd like to run an endurance test on an LDA to see how it handles several thousand rounds. There are, apparently, LDA models in use with many thousands of rounds through them with few problems, but we would be most comfortable finding out for ourselves.
We'll put the test gun through a long-term test and report back at a later date.
If you're a fan of the 1911 design but your agency has put the kibosh on the cocked-and-locked carry mode, introduce them to the LDA series from Para-Ordnance. Consider it "over the counter medication" for knee-jerk-over-reaction disease.
Roy Huntington continues to idle away large segments of otherwise productive time by shooting a never-ending array of guns for Police magazine. He's also the editor of American Handgunner magazine, and we remain skeptical whether either activity can properly be labeled as actual work.